Summarizing Individual Sensors into one Sensor

Modified on 2025-06-10 22:38:03 +0200

I have used the Paessler MIB importer to import the MIBs for an AudioCodes gateway. The Gateway has 4 FXO ports and with PRTG I am able to determine whether each of those ports is either on-hook or off-hook as each port shows as a sensor in PRTG. At this time, I am not concerned with the status of the individual ports, I only want to know the number of ports that are off-hook at a particular time. Is it possible to summarize the results from several PRTG sensors into one sensor?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

I was able to achieve this by using the "Sensor Factory" sensor.

Jan, 2016 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Summarizing Individual Sensors into one Sensor

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.