Hi,
How i can trigger an alert mail when "ID" event appear in event log
Monitor event log
Modified on 2025-06-10 22:39:42 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Set a limit as described here that will put the sensor into "error" when the event is found during a scan. Additionally create a State Trigger on the sensor's "Notifications" tab like "When sensor is down for 0 seconds, perform notification xyz".
Kind regards.
Jan, 2016 - Permalink