Solutions

NetApp QTree Monitoring

Modified on 2025-06-10 22:42:15 +0200

Hey Guys, I have a problem with one of my sensors - all of my qtrees are getting monitored, but with one of them i get an error that changes between "Logon Failure: connection in use (code: PE029)" & "access denied". Is there a way to write logs to a disk with this sensor? i want to know which folder is causing the problem.

Thanks in advanced,

Omri

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi,
What precise sensor type are you using here?
Best regards

Dec, 2015 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

NetApp QTree Monitoring

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.