Solutions

Reload channels of Windows CPU Sensor

Modified on 2025-06-10 22:42:30 +0200

Hi I use an win CPU Sensor to monitor a VM. The VM had 2 CPU's and know, I reduced to 1.

Can I reload the current setting so prtg shows only the current 1 CPU? Can I hide the other channels? Currentliy, each CPU(1,2) shows a value greater than 6'000'000 % In live data, the total percent is correct. I need only the total percent and not each cpu.

Best regards Christoph

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi there,

Channels cannot be deleted once they are created. You can either pause this sensor and create a new one to keep the historic data, or you can click on every particular channel to enter the channel settings. This will allow you to hide the channels either from the tables or the graphs, or from both.

Best regards, Felix

Dec, 2015 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Reload channels of Windows CPU Sensor

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.