Solutions

No traffic on 1 switch in the prtg

Modified on 2025-06-10 22:42:47 +0200

Good morning,

I have 8 hp procurve switches added with snmp and the bandwith sensor in prtg. And every switch has traffic details of the switch, except of one. What I tried to solve the problem: I deleted the sensors of the switch and added the sensors again, but this did not solve the problem. Any idea?

Thank you in advance.

Dirk

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi Dirk,

Do the sensors return an error message on this particular device, or are the sensors just returning zero values?

Best regards, Felix

Dec, 2015 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

No traffic on 1 switch in the prtg

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.