basically we want to monitor services up & down alert if port 443 is not reachable then we should g

Modified on 2025-06-10 22:43:12 +0200

What I am trying to do is to monitor the Https using PRTG using the port 443 so that I can get an alert that it is up or down.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Add a HTTP sensor to your device and then enter the URL as https://xxx.xxx.xxx.xxx replacing xxx with your DNS or IP. That sensor will monitor the port 443 for you and report if it goes down.

Dec, 2015 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

basically we want to monitor services up & down alert if port 443 is not reachable then we should g

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.