Anyway to group the NetFlow V5 sensor by IP

Modified on 2025-06-10 22:43:21 +0200

Ideally I'd like to be able to add a filter on the TopList's so I can see the breakdown of traffic to specific servers.

Currently the only way I can do this is by adding an additional sensor on the same filter and just apply the filter there. This works, but I think have filters on toplist's might be even more powerful.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello Ross,
thank you for your inquiry.

You're correct, currently the only way to achieve this is by adding new sensors based on the same flow with distinct filters. Toplists don't yet support filtering, but adding new sensors to the same "Flow Traffic" shouldn't have a big performance impact on your server.

Best Regards,

Dec, 2015 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Anyway to group the NetFlow V5 sensor by IP

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.