ESXi 5.5 Network throughput
Modified on 2025-06-10 22:44:56 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Hi,
I really like the amount of Data that is provided by the SOAP sensor. However it doesn't show the network bandwidth total. It shows the current throughput. We are only on version 15.3.18.3616+ so a couple back from the latest (not sure if this has been included in that or not).
Is that included in the newest version or is it on the time line to get completed?
Thanks.
Article Comments
Hi Josh,
Unfortunately that's also not the case in the current version. The thing here is that SOAP simply does not provide a counter that would enable such measurements.
Kind regards.
Nov, 2015 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi Josh,
Unfortunately that's also not the case in the current version. The thing here is that SOAP simply does not provide a counter that would enable such measurements.
Kind regards.
Nov, 2015 - Permalink