I created a new device using SNMP with following sensors Ping Uptime (002) eth0 Traffic Http
I create a device template. upon testing template the sensor http sensor Please check the URL setting for HTTP sensors created by device templates
How do I fix error "Please check the URL setting for HTTP sensors created by device templates"?
Modified on 2025-06-10 22:45:38 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Dear Dan
This message is automatically created by the device template. Please do check the URL settings of the HTTP sensor to make sure they are okay, and save the settings. The sensor should now operate.
Nov, 2015 - Permalink