Hello! I have a problem. Is it possible to realize in PRTG the following scenario: after 30 min "DOWN" sensor, trigger send notification that my branch unavailable. When sensor becomes a value "UP", after 30 minutes it was down, exactly 30 minutes, not 5,10 or 15 minutes, trigger send notification that my branch available.
Question about trigger
Modified on 2025-06-10 22:47:29 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi,
No, this is not possible. You can only trigger a notification when the condition clears but not when the condition clears after x minutes. Best regards
Oct, 2015 - Permalink