Cannot find out custom SNMP sensors when I import

Modified on 2025-06-10 22:48:13 +0200

Hi Support,

I just imported my custom MIB successfully and found oidlib files from D:\PRTG Network Monitor\snmplibs, but when I add an SNMP sensors I cannot found it, what should I do next?

Thanks!

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear smallfish

Please create an SNMP Library Sensor. During the creation, you are asked to select the OIDLIB in question. The sensor then scans which OIDs from that Lib are available on that device and creates one sensor for each OID.

Oct, 2015 - Permalink

It works! Thank you very much!

Oct, 2015 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Cannot find out custom SNMP sensors when I import

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.