Not reading power channel
Modified on 2025-06-10 22:48:26 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
After I upgraded prtg to version 15.4.20.4377 some channels in the VMware Host Performance (SOAP) just display value 0 for example the power meter and the networks receivers. If i revert to to previous version using vmware snapshop the sensors starts working again. I also tried to remove the sensor and adding it again but no luck.
What can I do to solve this issue?
Article Comments
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi,
what version of ESX(i) is installed on the affected hosts? Also please create a debug file as outlined in this article and forward it so support@paessler.com.
Best regards
Oct, 2015 - Permalink