On the alert emails, there is a Last Result text that corresponds I think with the Primary Channel's last result. So if I have Server A and the sensor is Disk Free and is monitoring drives C: D: and E: and the D: drive gets low on space, I will get an e-mail saying "Last Result 78% (Free Space C:)". The next row says "Last Message 14% (Free Space D:) is below the warning limit of 20%". I think the "Last Result" on multi channel sensors is very confusing. Can you make that the Last result of the channel that generated the alert in the first place?
Last Result is misleading on alerts
Modified on 2025-06-10 22:48:40 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi there,
You can remove the %lastvalue placeholder to avoid the confusion. The message is always created by the sensor itself and not from the channel. This is why it's not possible to enter a placeholder for a channel.
Best regards, Felix
Oct, 2015 - Permalink