Hello world,
I've added all my switches. They all have the same configuration but wome of them show that all the sensors are up while they aren't in the reality.
Thanks in advance.
Regards,
All sensors state are up
Modified on 2025-06-10 22:49:26 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
Within the settings of the Traffic Sensors it is possible to specify the "Connection Status Handling". For your desired outcome, set-them to 'Show alarm for all "disconnected" states'. The default is 'Ignore all "disconnected" states.'
Oct, 2015 - Permalink