Adding Sensors to remote probe
Modified on 2025-06-10 22:51:16 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Dear Paessler
I've add a remote sensor on a branch PC and I want this PC to collect all the branch data (SNMP, WMI..etc)
currently I see only sensors on the branch PC (health, CPU .. etc) I need to sense other devices like a network UPS firewalls servers but I dont know from where to start?
Article Comments
Hello Ahmed,
in order to create sensors to monitor other devices on the remote probe, create a Device (with the IP address of the firelwall device) first.
Afterwards you can create sensors on the devices. If you would like to create devices and sensors automatically, you can use the auto discovery.
Sep, 2015 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello Ahmed,
in order to create sensors to monitor other devices on the remote probe, create a Device (with the IP address of the firelwall device) first. Afterwards you can create sensors on the devices. If you would like to create devices and sensors automatically, you can use the auto discovery.
Sep, 2015 - Permalink