Hello Dears,
I just downloaded PRTG 30 days trail version and I need to know if there's any way I can add a test to ping multiple IP's in the internet and record the value.
can this be done through prtg and if yes, How?
Thanks
How to add multiple devices for one test
Modified on 2025-06-10 22:52:56 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi Abdulla,
Thank you very much for your interest in PRTG Network Monitor. There are multiple ways to add new devices and create a Ping Sensor, but I think using the Auto-Discovery will be the fastest here.
Create a new group and choose
Sensor Management > Automatic sensor creation using specific device template(s) > Generic Device (Ping only)
This will only create an Ping sensor for multiple sites. You can choose List of individual IPs and DNS names (IPv4) to enter the IP addresses line by line.
Enjoy the testing! :)
Best regards, Felix
Sep, 2015 - Permalink