Solutions

No Such Name (error SNMP # 2)

Modified on 2025-06-10 22:53:10 +0200

Hello everyone;

I´m trying to set the SNMP Memory for Linux (Ubuntu) but when I finish to setting I got that error.

I followed this step: It might not work to query data from a probe device via SNMP (querying localhost, 127.0.0.1, or ::1). Add this device to PRTG with the IP address that it has in your network and create the SNMP sensor on this device instead. For a general introduction to the technology behind SNMP, please see the manual section Monitoring via SNMP.

But anything happen.

Could you give me somo hints?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

You have to create a new device in PRTG. Change the settings accordingly (credentials, snmp community, etc.) and add a new SNMP sensor - this should work then :)

Sep, 2015 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

No Such Name (error SNMP # 2)

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.