Why is one connectionstate gauge backwards?

Modified on 2025-06-10 22:53:12 +0200

I have setup a sensor with 4 channels, 2 of which should show an error if offline. The other 2 should not be an error if they are offline. I am using prtg.standardlookups.connectionstate.stateonlineok and prtg.standardlookups.connectionstate.bothok.

The guage for prtg.standardlookups.connectionstate.stateonlineok points to the right for a value of 1 (and left for a value of 0).

The guage for prtg.standardlookups.connectionstate.bothok points to the left for a value of 1.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

This is state depending and always goes clockwise. Green at the start, red at the beginning. All values resembling the same state will appear in order of appearance in the lookup.

Sep, 2015 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Why is one connectionstate gauge backwards?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.