chek list sensor prtg in checkpoint firewall

Modified on 2025-06-10 22:53:52 +0200

hai fellas,

i have some sensor in prtg to monitor my checkpoint firewall, but i don't know details of that sensor how to check that sensor in my checkpoint? my checkpoint run in IST 2010 i686 i686 i386 GNU/Linux

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear Dani

Please specify your question. If your firewall supports a standard protocol like SNMP, you can monitor it with PRTG. Perhaps you need to import the MIB files first, which are descriptions of the OIDs used to monitor the device.

Aug, 2015 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

chek list sensor prtg in checkpoint firewall

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.