Applying lasted upgrade, don't want to unpause sensors

Modified on 2025-06-10 22:54:15 +0200

I noticed that whenever we do updates after the update completes ALL sensors that were paused previous are now unpaused and sometimes I have 200+ that I have to go back and repause, IF I remember them all...

Any suggestions how to keep the same config. during the whole process so after I am done it stays the same paused and unpaused?

Much appreciate the help1!

Tom

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Are they paused manually or by dependency? The latter might cause them to be resumed on restart. The first one should survive a reset.

By the way, you can show them all by going to Sensors > By Current Status > Paused, to make sure you don't miss them.

Aug, 2015 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Applying lasted upgrade, don't want to unpause sensors

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.