The sensor works great. Now I want to send an email notification when the sensor is triggered along with the detail of the sensor. The sensor is filtered on a specific Event ID.
Using WMI Event Log Sensor
Modified on 2025-06-10 22:56:16 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Good to hear the sensor is working well for you. Regarding the notification, simply enter the sensor's 'Notifications' tab. If inherited notification triggers are already in place, select option 'Only use triggers defined below', add a 'Change Trigger' to perform the desired notification. You'll get notified with the sensor's details as soon as a new eventlog is found matching your criteria. Be aware that if this event occurs several times between two scans you'll get one notification not one notification for every new item.
Aug, 2015 - Permalink