I would like to set alarm and warning thresholds on the SSH Load Average and SSH Load Average v2 sensors, but I can not find any place in the sensor or channel settings to effect that.
Where do I make that change?
How do I set alarm and warning thresholds on the SSH Load Average sensor?
Modified on 2025-06-06 11:27:01 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello Josiah, thank you for your contact.
Please check the Sensor's Channels Settings, there you can Enable Limits and then Configure one or more of the following:
After you've set-them-up, you can configure State Triggers to send notifications for Warning or Error statuses.
Jul, 2015 - Permalink