Hi! When I'm deploying router device from previously created template, I'm having snmp bandwidth sensors on each port. But in my template there were a few senosrs on certain ports. What's wrong, I need a template with a few sensors, how can I create it?
Article Comments
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Hello,
Please note that there are settings than cannot be saved in a Device Template. Among of these settings are sensors that dynamically scan for available monitoring items when you add the sensor (such as Traffic sensor).
The issue with Network Adapters is that most systems will have many, the same applies to hard disks. As PRTG doesn't know "which one you want to monitor". During an auto-discovery PRTG will query the target host for a list of existing adapters/interfaces. It will then deploy one sensor per active/existing interface. This behavior cannot be changed I'm afraid.
However, this article may be of interest for you: https://helpdesk.paessler.com/en/support/solutions/articles/76000065217-network-adapter-template
Kind Regards,
Timo Dambach
Paessler Tech Support
Feb, 2020 - Permalink
Hello,
Please note that there are settings than cannot be saved in a Device Template. Among of these settings are sensors that dynamically scan for available monitoring items when you add the sensor (such as Traffic sensor).
The issue with Network Adapters is that most systems will have many, the same applies to hard disks. As PRTG doesn't know "which one you want to monitor". During an auto-discovery PRTG will query the target host for a list of existing adapters/interfaces. It will then deploy one sensor per active/existing interface. This behavior cannot be changed I'm afraid.
However, this article may be of interest for you: https://helpdesk.paessler.com/en/support/solutions/articles/76000065217-network-adapter-template
Kind Regards,
Timo Dambach
Paessler Tech Support
Feb, 2020 - Permalink